Argox PA-60 Manual do Utilizador descarregar pdf (Página 22)

2. nce the options are incorrectly selected, the LEDs at panel may become blinking

after printing. Please refer to the trouble-shooting section to correct the errors.

O Selects Options

3. For X series the thermal transfer and direct thermal are set via DIP switches, not by

this command.

Syntax O[D,C,N]↵

Description This command is used to select various printer options. In

general, it depends on the configuration of your printer.

Parameters D: Enable Direct thermal (without ribbon).

C: Enable cutter.

N: Enable dispenser.

Every time when the printer is started up, the defaults

are cutter disabled, and dispenser disabled.

Example O↵ ; thermal transfer, disables cutter

and dispenser

OD↵ ; direct thermal, disables cutter and

; dispenser

OC↵ ; thermal transfer, enables cutter and

; disables dispenser

Notes:

1. The cutter and dispenser cannot be enabled at the same time.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 40 41

Sem comentários

Argox PA-60 Manual do Utilizador Página 22